The XH-M452 humidity and temperature controller (ZFX-M452) is designed to maintain the programmed temperature and humidity by turning on / off the heating / cooling and humidifying / dehumidifying devices connected to it.
This is possible because the XH-M452 Electronic Temperature and Humidity Controller has two output relays.
The XH-M452 electronic temperature and humidity controller is of a relay type , that is, when the set temperature or humidity is reached, it closes or opens the output contacts like a conventional switch.
Setting precision: 0.1
Display precision: 0.1
Maximum load current: 10 Amperes (during continuous operation it is better not to exceed 80% of the maximum)
The regulator has two displays - red for temperature, blue for humidity readings.
With a short press on "+" - the display will show the lower threshold of the temperature / humidity value.
With a short press on "-" - the display will show the upper threshold of the temperature / humidity value.
To change the lower threshold:
1) hold down the "+" button for 3 seconds, the display will start blinking, then use the "+" and "-" buttons to set the value you require. 2) to save, you need to wait 5 seconds.
To change the upper threshold:
1) hold down the "-" button for 3 seconds, the display will start blinking, then use the "+" and "-" buttons to set the value you require. 2) to save, you need to wait 5 seconds.
The setting rules are the same for both temperature and humidity.
The humidity is regulated by two upper and lower thresholds, which are adjustable in the range from 0% to 99%.
1 x H-M452 Incubator Temperature Humidity Controller
No posts found