Sensors & Modules

Rs. 58  
The 1s 3a 3.7v Li-Ion Bms PCB Protection Board uses the original Fujing imported components. With overcharge, over discharge, over current, short circuit and other protection functions, for a variety of shapes of various shapes 3.7V lithium battery. It adopts rich crystal protection IC, high...
In stock
+

Rs. 318  
Charging module for Li-ion batteries that monitors the charge level and prevents damage to lithium batteries due to incorrect charging cycle. The module allows you to connect up to 3 batteries and charge them with a total current of up to 25A.  Specifications: Maximum operating...
In stock
+

Rs. 294  
Specifications: 3S 40A 12.6V 40A lithium battery protection board (comes with recovery function-AUTO Recovery) Scope: Nominal voltage of 3.6V, 3.7V lithium battery (including 18650,26650, polymer lithium battery) Product weight: 9.8g (balanced version) Charging voltage: 12.6V - 13.6V...
In stock
+

Rs. 372  
Features: 4S 16.8V 40A 18650 lithium battery protection board (comes with recovery function-AUTO Recovery) Integrated 10 low load resistance MOS tube, continuous discharge 40A, 100mA balanced current, for electric drill/sprayer/LED lights/low power inverter Continuous discharge current...
In stock
+

Rs. 833  
0
HW-525 ACS758 Hall Effect Linear Current Sensor Module Parameter: Working voltage: 3 -5V (MAX 8 V) Static output voltage: VCC / 2 Working current: 13.5mA (MAX) Storage temperature range: -65 ° C -165 ° C Maximum output current (VIOUT-GND): 3mA Internal Bandwidth: 120KHz Module Size: 37mm *...

Contact us for a price  
★The module is adjustable buck module, you can adjust the module by adjusting the above blue sinking resistor to change the output voltage. Input and output voltage is 1V, the minimum output voltage of 0.8V. ★IN- (input negative), IN + (input positive), OUT- (output negative), OUT + (output...
In stock

Rs. 250  
Accurate sensor to measure AC/DC current up to 5A. The sensor can even measure high AC mains current and is still isolated from the measuring part due to integrated hall sensor. The board operates on 5V. ACS712 current sensor operates from 5V and outputs analog voltage proportional to current...

Rs. 294  
0
5A range of single-phase ac current sensor module can measure AC currents less than 5A, the corresponding analog output 5A/5mA. It has Onboard sampling resistor and precision microcurrent transformer do accurate sampling for the signal and appropriate compensation, and other functions. The module...
In stock
+

Rs. 2,352  
What is USB Host Shield? USB Host Shield, is a module that you can mount to the Arduino Uno, Duemilanove and Mega boards, so that they work like a USB Host and thus can control slave devices, such as: USB memories, keyboards, mice, bluetooth modules, etc. This module is based on the...
In stock
+

Rs. 117  
Specification The DO output interface can be directly connected to a micro-controller IO port, if there is a block detection sensor, such as the speed of the motor encoder can detect. DO modules can be connected to the relay, limit switch, and other functions, it can also with the active...
In stock
+

Rs. 215  
Features: The attribute of the lithium battery protection board: Maximum working current: 8 a working temperature: - 40 - + 50 ° Maximum instantaneous current: 10 a storage conditions: - 40 - + 80 ° Model: HX - 2 s - D01 charging pressure range: 4.25 + / - 0.05 v to 4.35 v Size: 41 *...
In stock
+

Rs. 450  
0
CJMCU-101 is an integrated chip built-in photodiode and transimpedance amplifier the output voltage increases linearly with the light intensity . Amplifier is a single supply or dual power supply design so can be used for battery-operated devices. Integrated photodiode and transimpedance...

Rs. 1,274 Rs. 1,650  
The XH-M452 humidity and temperature controller (ZFX-M452) is designed to maintain the programmed temperature and humidity by turning on / off the heating / cooling and humidifying / dehumidifying devices connected to it. This is possible because the  XH-M452 Electronic Temperature and...
In stock
+

Rs. 850  
Features: This delay relay switches on for some time after power-on, then switches off for some time, and cycles the above process. Output adopts optical coupler isolation to strenhen the anti-interfere ability. Industrial grade circuit board, stable performance. With power-off memory...
In stock
+

Rs. 490  
A USB to Ethernet adapter is a device that is capable of connecting a USB port to an Ethernet cable. USB to Ethernet adapters allow users to connect multiple devices together via an Ethernet cable rather than using a USB cable, which is generally shorter and less reliable. USB to Ethernet...
In stock
+

Rs. 176  
Description Temperature-Humidity Sensor DHT11 Onboard Weather station, humidity controller, test & detection device Standard single-wire interface The  DHT11 Temperature-Humidity Sensor Module  is a calibrated digital temperature and humidity module with onboard sensor...
In stock
+
1 2 3