The XH-M452 humidity and temperature controller (ZFX-M452) is designed to maintain the programmed temperature and humidity by turning on / off the heating / cooling and humidifying / dehumidifying devices connected to it.
This is possible because the XH-M452 Electronic Temperature and Humidity Controller has two output relays.
The XH-M452 electronic temperature and humidity controller is of a relay type , that is, when the set temperature or humidity is reached, it closes or opens the output contacts like a conventional switch.
Setting precision: 0.1
Display precision: 0.1
Maximum load current: 10 Amperes (during continuous operation it is better not to exceed 80% of the maximum)
Specifications:
- Model: XH-M452
- Supply voltage: DC 12V (DC 12V)
- Maximum current through relay contacts: 10A
- Temperature measurement and control range: -40 ~ 99.9 ° C
- Humidity measurement and control range: 0 ~ 100% RH
- Control accuracy: 0.1 ° C 0.1% RH
- Calibration range: +/- 9.9
- Board dimensions: 65x55x27 mm
Setting instructions:
The regulator has two displays - red for temperature, blue for humidity readings.
With a short press on "+" - the display will show the lower threshold of the temperature / humidity value.
With a short press on "-" - the display will show the upper threshold of the temperature / humidity value.
To change the lower threshold:
1) hold down the "+" button for 3 seconds, the display will start blinking, then use the "+" and "-" buttons to set the value you require. 2) to save, you need to wait 5 seconds.
To change the upper threshold:
1) hold down the "-" button for 3 seconds, the display will start blinking, then use the "+" and "-" buttons to set the value you require. 2) to save, you need to wait 5 seconds.
The setting rules are the same for both temperature and humidity.
- Humidity control in the range from 0 to 99%,
- Board size 65 * 55
- Supply voltage: + -12V
- Maximum current of the output relay contacts: 2x10A, 220 Volts
- Power consumption, no more: 3 W
- Sensor type SHT20
- Temperature range -40 +120
- Has LED display, LED relay status indicator
- Two control buttons "+" and "-" for each channel
- Terminals "+ 12V / GND" for board power supply
- Terminals for connecting the load
- Sensor remote sensor wire length 1m
The humidity is regulated by two upper and lower thresholds, which are adjustable in the range from 0% to 99%.
Package Includes:
1 x H-M452 Incubator Temperature Humidity Controller
