The Mosfet Power Module Ha210n06 is a type of control for the heated table of 3D printers based on Ramps 1.4 Anet A8 controllers among others allowing greater application possibilities.
Most controllers allow maximum currents of 15A being subject to serious damage in case of spikes or higher currents in order to cause damage to the entire set of electronic components of the printer.
Very practical the Mosfet Power Module Ha210n06 has an aluminum heat sink that allows currents of up to 25. If you want higher currents it is necessary to install some type of active cooling system.
The connection to the controller is made using a 2-pin JST cable (included) in addition to having its own location for fixing the wires that will manage the energy input and output of the Heated Table.
CHARACTERISTICS:
- - Mosfet Power Module 210A HA210N06;
- - Control Module for Heated Table 3D Printer;
- - Compatible with 3D Printer Ramps 1.4 and Anet A8;
- - Ideal to amplify the capacity of Printers;
- - Intermediates the connection with the Hot Table;
- - Prevents burning of components due to excess current;
- - Extends the maximum load from 15A to 25A;
- - Aluminum heatsink already integrated;
- - With active heatsink allows currents up to 210A; (Not included)
- - Includes JST connector cable;
- - Datasheet Mosfet HA210N06:
SPECIFICATIONS:
- - CI: HA210N06;
- - Maximum current: 25A (without active heatsink);
- - Maximum current: 210A (with active heatsink);
- - Voltage: 12V / 24V;
- - Compatibility: Controller Ramps 1.4 Anet A8 and others;
- - Dimensions (LxWxH): 60x50x27mm;
- - Weight: 35g.